kevinmichaelcoy.com

For a couple months my Roomba has been acting a tad bit funny by pretty much not working. Anytime I would attempt to get my Roomba running, it would immediately start producing a clicking noise and then cease cleaning. The following error would be announced “Error 2. Open Roomba’s brush cage and clean brushes.” Now, my Roomba was fairly new and I know people tend to have lots of problems with them, so I started to think I had a dud and just resumed using my regular, old-school vacuum. I did attempt cleaning the brushes a few times, but to know avail. Finally, today I decided to look for an answer and found it here. The trick was removing the brush bearings, which I was unaware of them being able to be removed. Finally, my Roomba is back in order and I hope this helps anybody else who may be experiencing a similar problem

I have been delegated the task of scanning the family photos and I picked up an Epson Perfection V500 to perform these duties, since I could not find any real options with a feeder. I’ve used it off and on for the past few months without a problem and have found it to be quite useful, fast, flexible, and convenient; however, today in the midst of scanning some negatives I lost the option to select Film as a ‘Document Type.’ To recover from this problem I turned off my scanner, and unplugged everything in the back for a few seconds and then reversed the process. Click here to get more information on this problem.