Roomba Triage
by Kevin on May.21, 2010, under Technical
For a couple months my Roomba has been acting a tad bit funny by pretty much not working. Anytime I would attempt to get my Roomba running, it would immediately start producing a clicking noise and then cease cleaning. The following error would be announced “Error 2. Open Roomba’s brush cage and clean brushes.” Now, my Roomba was fairly new and I know people tend to have lots of problems with them, so I started to think I had a dud and just resumed using my regular, old-school vacuum. I did attempt cleaning the brushes a few times, but to know avail. Finally, today I decided to look for an answer and found it here. The trick was removing the brush bearings, which I was unaware of them being able to be removed. Finally, my Roomba is back in order and I hope this helps anybody else who may be experiencing a similar problem
July 15th, 2010 on 10:55 pm
thanks for the roomba bush bearing hint! I fixed my roomba, :yay:
obviously this should be mentioned in the manual as it is bound to happen to everyone eventually.
September 4th, 2010 on 9:29 am
Hi,
the link is broken, I got the samme issue, could you put it back or explain how you got rid of that one ?
thanx